Primare SP31.7 Betriebsanweisung PDF herunterladen (Seite 29)

Saving the configuration

This chapter explains how to save the configuration of your SP31.7, and how to recall a saved

configuration, or reset the SP31.7 to the factory settings.

INTRODUCTION

Once you have defined your own custom set of inputs, and

have calibrated the speaker settings and other configuration

options to suit your own requirements, you should save your

settings permanently in the SP31.7. You can then return to

your saved settings at any time using the RECALL

SETTINGS option to undo any subsequent configuration

changes.

If the SP31.7 was set up for you by an installer, the installer

will have saved a set of installer settings. You can also return

the SP31.7 to these settings using the RECALL

INSTALLER SETTINGS option.

Finally a RECALL FACTORY SETTINGS option is

provided, to return the SP31.7 to the default factory settings.

After saving or recalling settings always wait at least 10

seconds before switching off the unit using the mains switch.

To save your settings

• Highlight MEMORY in the SETUP MENU and press

the SELECT button on the front panel or remote control

to select it.

The MEMORY MENU will be displayed:

• Highlight SAVE SETTINGS and press the SELECT

button on the front panel or remote control to select it.

After a short delay a message will confirm that the settings

have been saved:

• Wait 10 seconds to allow the settings to be completely

stored.

• Press the MENU button on the front panel or remote

control to return to the MEMORY MENU.

To recall your settings

• Highlight RECALL SETTINGS in the MEMORY

MENU and press the SELECT button on the front panel

or remote control to select it.

The following screen then confirms that your settings have

been recalled:

§8 Saving 26/7/02, 12:52 pm25

1 2 ... 24 25 26 27 28 29 30 31 32

Keine Kommentare

Primare SP31.7 Betriebsanweisung Seite 29